|
Use a utility knife to shave a flat spot on end of card. You will notice a soft spot when you are deep enough. Cut out the soft spot. (end of usb cable should slide in firmly)
|
Now modify usb cable. Cut end off cable with about three inches of wire left. NOw use utility knife to remove insulation from cable and connector. I also removed the metal strain relief from connector to shorten it up. Remove shielding and ground wire from cable(ground wire has no insulation. you should have black, red, white and green wires left)
|
Now disassemble memory card. Remove circuit board from black rubber end, insert usb connector, slide circuit board back in being careful of wires. Now cut wires to legnth and solder start at left 1: black 2: not used (Xbox yellow wire) 3: green 4: white 5: red
|
